Coffee Forums banner
Cancel
Create thread New Forums

Search results for query:

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. Eureka Grinders
    The stalling issues I have been experiencing in the past resolved. I am not sure what was the culprit, but I feel like the better alignment with the sandpaper method worked really well. The new carrier’s surface has been rather rough, so some sanding did the work. Also The grind setting for...
  2. Eureka Grinders
    It's probably due to the bigger burrs you put on the grinder. While it has the power to rotate the carrier sometimes jams on start. I am not sure and wonder whether putting a bigger capacitor like the one on Olympus 75e will fix the problem.
  3. Lelit Forum
    Guys I am confused as well but my problem seems slightly different. Pump gauge reads 9 bar while group head gauge goes straight to 10,5 bar!! I am not sure whether the water expansion due to heat applies in my case because I do the test when the Bianca is totally cold (immediately after switches...
  4. Eureka Grinders
    Dany who is the alligment with the new carriers? Is it ok?
  5. Eureka Grinders
    Dany i see two different codes for the upper carrier: Upper burr carrier: 729055 - Fashion & Olympus (visible only in Fashion spare-parts manual) Upper burr carrier: 729033 - UPPER BURRS HOLDER OLYMPUS CONIC (visible only in Olympus spare-parts manual) Any clues?
  6. Eureka Grinders
    Hi Dany, very good attempt i am about to do it as well! But i have a couple of questions first since there are some differences in part numbers from year to year. 1. Is there a small typo in the upper burr code you posted? Eureka Olympus 75e grinder codes: Upper burr holder: 2414.0005 (is it...
  7. Eureka Grinders
    The retention is about 6-8gr. Not bad for an on-demand grinder. If you remove the clump crusher you got a very impressive reduction in the amount of retention. Chute holds 2to3gr only!
  8. Eureka Grinders
    I generally avoid to remove the burrs from carriers. I used to, but now I don't. The reason is that you are not sure that the burrs will be perfectly aligned. You may have to spend days (and coffee!!) for fixing them in a parallel and vertically aligned position.
  9. Eureka Grinders
    Zenith 65e among others. I enjoy playing with it. It is also too easy to dial and a very good looking grinder.
  10. Eureka Grinders
    Make sure that you are not grinding too fine. If this is not the case, remove the clump crusher you may see major improvement!
  11. Eureka Grinders
    Did you remove all the clump crusher assembly or just the flaps. I think there is a gap between the chute an the nozzle when you remove the whole clump crusher, right? Or this just concerns only the 65e grinder?
1-11 of 11 Results