Search results for query:
Discussions Showcase Albums Media Media Comments Tags Marketplace
1-9 of
9 Results
-
AccessoriesLooking to buy a bottomless portafilter for an old Gaggia (58mm). Preferably genuine Gaggia. Used condition is fine. Let me know what you've got. Thanks!
- 0
- 545
-
🪛🔧 Technical | Faults | How-to's ❓ℹNice! Thank you @Rincewind I will certainly try the WD40 on the bearing next. The reason I opened it right up was to see if I could just install a new bearing but I couldn't figure out how to remove the big gear wheel on the opposite side of that shaft. I will open it up again and take photos if...
- 4
- 986
-
🪛🔧 Technical | Faults | How-to's ❓ℹHi. Is this speaking from experience / reading about this issue before or just an idea? I have just been re-watching that top video and when you really focus around that center nut, you can see it's almost like the brakes are put on for a fraction of a second every time the chirp occurs. So odd.
- 4
- 986
-
🪛🔧 Technical | Faults | How-to's ❓ℹHi. Just wondering if anyone can help with this or if you can point me in the direction of a more suitable forum. Gaggia MDF grinder has this annoying intermittent chirping noise. I presumed it must be the burrs but after a complete tear-down, I found that it is actually motor related. I have...
- 4
- 986
-
Gaggia ForumThanks @Uncletits I got this machine for £40 and luckily it was just clogging which caused it to be advertised as spares/repair. I've actually never made an espresso in my life! I see this as a starter machine and I'll see if I keep it up before considering an upgrade. Not too keen on the...
- 5
- 1.2K
-
Gaggia ForumThe machine was on for around 10 minutes, possibly even a bit less. The manual says the machine should be ready in 6 minutes. Do you think waiting 20 minutes would make a near 30 degree C difference? When I had it stripped, I did remove the stats, cleaned off the old thermal paste and...
- 5
- 1.2K
-
Gaggia ForumI'm at the final stage of refurbing this old Gaggia "ESPRESSO". I have completely stripped and cleaned it. Installed new o-rings + a blue silicone Cafelat group gasket. After reassembling, I discovered the steam wand was leaking terribly so I performed the valve modification. Now...
- 5
- 1.2K
-
Gaggia Forum* WARNING * Amateur strikes again ???????? Thought I would post about my experience to give you seasoned engineers a laugh! I ended up with an old adjustable die and after my first pass, the nut worked but it seemed a bit wobbly (only during the screw, no movement once fully tightened)...
- 152
- 50K
-
1-9 of
9 Results