-
Yes this should be relatively easy to do. I happen to have the same grinder and while I haven't modified it, I have modified another...
-
Most suitable and good value enclosure I've used is a Hamond 1591 (black plastic). Have also used a tuppaware type enclose too as a stop...
-
Teetertank commented on the thread
Greetings.
It's a Porlex I've been using, which I guess has the same or similar grinding mechanism as a Hario. I did initially bring in a nice...
-
Teetertank commented on the thread
Greetings.
Hi Mildred,
I enjoy using the Flair though it is a bit of a faff having to get the brew chamber warmed up and gets somewhat messy...
-
Did you prime the boiler first? If not, then when the machine is cold, try opening the steam valve then hit the brew switch until water...
-
Hi Joey,
Do you have any bases around 58.6mm (or close?)
...don't necessarily need a handle.
If you do, I'm interested in one. Thanks.
-
Teetertank commented on the thread
Olympus burrs.
The grinder is an Olympus K and the burrs are the conical variety. E13/68 code.
If these do need replacing are there any good sources...
-
I inspected the burrs on my grinder recently and noticed the edges on the burrs weren't as crisp as I was expecting.
I purchased it...
-
Teetertank commented on the thread
Isomac Millenium.
There is not that much difference between the different versions.
Fot the millenium, the original version had a single guage for the...
-
Teetertank commented on the thread
Isomac Millenium.
Hi Scribblez,
Don't know if you're still considering this machine. I went on this same route, from Gaggia Classic to Isomac Millenium...
-
Hi,
Time to say hello, been lurking on this forum for a while.
There's some great info on this site, but I've also found it pretty...
