-
look here:
and here:https://youtu.be/OGVX54-VMq0
It is perfect, with both burrs, Mahlkonig and SSP burrs.
greetings
juergen
-
EK43 Limited, alignment by sanding technique nearly below 5um or better, new red speed SSP burrs mounted, consider parallactic needle...
-
@bpchia
ad1)
First put the glue to the sandingpaper backside and at the burr backside, wait 15 minutes and put them together. Next cut...
-
@bpchia
any questions?
Greeting
Juergen
-
The misalignment of the carrier can not be transmitted to the grinding housing during grinding because only the high point determines...
-
Clogging is a sign of abrasive result. Perhaps you have to change to 200 grit paper.
You have finished, when the scrub marks takes 360...
-
Sound of EK43 with 5um alignment, fixed and rotating burrs:
Thanks to Matt Perger for the fake alignment:waiting:
greeting
juergen
-
-
One pitch for one rotation is normal, even by poor alignment, by excellent alignment too.
Multiple pitches per rotation is a sign of...
-
-
You habe to clean the sandpaper every 30sec., of course, and you need cutting oil.
-
Yes ,very curious, please, for this request MP.
-
Sanding technics of EK43 alignment summary ( in my opinion):
The EK43 must be aligned like any other mill for grinding Espreeso.
For...
-
Sanding the normal EK43 carrier, which ist made of stainless steel is possible too. I´ll try it this week.
So long
Juergen
-
-
Update for the sanding method to adjust the EK43 grinding house.
to make a burrs-double pack, the best way is to take tesa tape:
-
In fact, this was my first idea: sanding the grinding house bottom by motor power using the grinder itself und using the adjustment...
-
tightening torques for EK43
grinding house M4: 1,4 Nm
burrs M5 (fix and rotating): 2,8 Nm.
-
Here my radial alignment of the EK43 burrs
First disassemble the grinder and remove the distance bush from the shaft.
Mount the fix...
-
The chassis parts are the same.
The grinder housing is fit to the motor housing using a spacial machine. It's a machine-guided merge...
-
All EK43 are not aligned, only the EK43 limited Edition. The LE is adjustet below 30 um, for my sense not good enough, but MK thinks...
-
The EK43 is a coffee grinder from the 70th. The manufacturing process did not changed so long. So, today the EK 43 is still a coffee...
-
Here is the historical post #1100 in german kaffee-netz.de, thread "Erfahrungsaustausch EK43: Schwerpunkt Alignment / Ausrichtung"
at...
-
Measurement of the EK 43 fix burr after the sanding method.
The video for disbeliever.
After square correction (cosine failure) I...
-
It's no problem. Try it and have fun.
jupe2.0 commented on the thread EK 43 alignment grinding chamber.look here: and here:https://youtu.be/OGVX54-VMq0 It is perfect, with both burrs, Mahlkonig and SSP burrs. greetings juergen
